How to install a deadbolt

Step 1:
Reference the Manufacturer's Template
Most deadbolt-lock manufacturers present a template to help you set up the lock.
The template is designed to work with doorways of various thicknesses and has reference points that could be marked on the door with an awl.
The deadbolt should be not less than 6" above your doorknob.
Step 2:
Cut a Gap for the Deadbolt
After you mark the reference points from the template, use a hole noticed to start chopping the opening for the deadbolt When the pilot
bit on the opening noticed comes by means of the opposite aspect of the door, cease cutting. End the hole from the opposite facet of the door to prevent splinters.
In case your hole noticed is not deep sufficient to penetrate the outside face of the door, use a normal bit to complete drilling the outlet you may use as a reference point.

Step three:
Drill a Gap By means of the Fringe of the Door
Use a 1 1/2" spade bit to drill a gap via the edge of the door for the bolt.

Step four:
Mortise the Space Across the Faceplate
Dry-fit the bolt into the outlet, and trace around the faceplate.
Use a wood chisel to mortise the realm around the faceplate in order that it will be flush with the door. When using the chisel,
keep the beveled aspect in toward the mortised space, and faucet the instrument deep enough to recess the faceplate.
Chances are you'll need a smaller chisel to mortise the rounded corners.

Step 5:
Secure the Bolt To the Door Proceed mortising till the faceplate suits properly. Drill pilot holes, and secure the bolt to the door with screws.
Step 6:
Set up the Cylinder And Thumb Lever
Dry-fit the cylinder and thumb-turn plate so you'll know the way the pieces fit together. Match the exterior aspect onto the door first,
ensuring the writing is upright. Then set the interior piece in place, and align the screw holes with the mounting holes inside the lock.
Fasten the deadbolt in place with screws.
Step 7:
Drill Holes and Safe the Strike Plate
Mark the top of the bolt with lipstick or paint. Close the door, and switch the deadbolt a number of times to mark the doorframe. Use a 7/eight" spade bit to
drill two overlapping holes in the doorframe for the deadbolt.
Mortise the world around the hole so the strike plate will match flush with the doorframe. Drill pilot holes and safe the striker plate with screws.

Article Source: http://www.gamblingarticlessite.net

For more information visit our web Locksmith calgary Locksmith honoluluLocksmith hawaii

Please Rate this Article

5 out of 54 out of 53 out of 52 out of 51 out of 5 

Not yet Rated